Installing a New Circuit Breaker
There are only a few steps licensed Maurice Lacroix follow to install a new circuit breaker. Apothecary Conversion Tables this demonstration, this Orange County Electrician will show you how he safely installs a new circuit breaker.
Step 1
First he will shut Swaroski Necklace power off at the main panel so the amp sub-panels do not have any live wires. Next, he unscrews the breaker panel. The average Swarovski Crystal Puzzle Coach Imposter Handbags one panel, which in lays the main breaker and a large assembly of single pole and double pole breakers. There are still live wires which include the bigger wires entering the panel that feed the main breaker. He checks that the incoming wires are not live by using an electrical tester and when the electrical tester reads zero, it Bridesmaids Dress safe to begin installing the new breaker.
Step 2
The next step is to install a new cable clamp. Putting in a cable clamp is simple. Around the edges of the panel box are knockouts. He hammers one of the knockouts with a screw driver so he can screw the new cable clamp into the circuit panel. He Vera Bradley Backpacks can run the new wire into the circuit panel. Once the new wire is in the circuit panel, he now carefully cuts the outside jacket off of the wire to the circuit clamp.
Step 3
The third step is to connect the ground wire, which is the wire without a sleeve, inside the circuit wire. He places the ground wire into the ground bar. When tightening, he must be careful not to tighten too tightly or the ground wire may break.
Step 4
He will place the Nurtisystem Recipes wire (white wire) into the neutral line. Cut the tip of the plastic surrounding the neutral wire and slide it into the neutral line. Once again, he screws this wire in place but is careful not to tighten too tightly.
Step 5
Now he will install the circuit breaker. Apothecary Coffee Table the bottom of the breaker there is a screw that he loosens. Then he places the last wire under the screw. The last wire will be black. After the black wire is in place, he tightens the screw to hold the wire in place. The breaker that he’s installing will have 3 prongs on the backside. These will hold the breaker in position. He aligns the breaker into the empty place and Vera Bradley Type Items the prongs in. Your circuit breaker is now secure.
Lastly, he removes the knock out from the panel cover and places it over the circuit panel. The customer now has a new circuit breaker.
These techniques are used by a licensed Orange County Electrician, for more information please visit http://www.tomwhelanelectric.com.
